I've always liked the internal MyIDE because it keeps the cartridge slot open for useful things like OSS language carts. In addition, the flashable OS is very useful for beta testing. Today I was able easily to fit an Internal MyIDE into a RamRod XL (three-way switched OS board) in an 800XL Plenty of room! Minor problem -- the MyIDE board "takes over" the system, even if it's control wires are disconnected. Bummer -- thought I was going to get Omnimon at the flip of a RamRod XL switch. Is there any way to do this -- perhaps put a switch on pin 1 of the RamRod socket with the MyIDE in it? Perhaps Steve could answer next time he reads the board? (Yes, I could just flash Omnimon in the MyIDE module, but I do like to minimize flashings, and I use Omnimon a lot.)
Post subject: Re: How to make the Internal MyIDE "transparent?"
Users browsing this forum: No registered users and 2 guests
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum