Sijmen before i can iuse MYBIOS 4.8.0A do i need to create a partition on the hard using the 3.1 disks ?
Once a partition has been created do i then use SETUP48DE then reboot with LOAD48DE ?
When pressing the 3 buttons down i'm not getting in to the menu? it just keep rebooting from LOAD48DE in D1:
If i don't touch anything i can see the words at the bottom of the screen light up and as soon as its got to the end it reboots just like when i press all 3 buttons?
GGGRRRRRRRRRRRRR This is madness all i want to do is get in to that menu system so i can set the hard drive up? Everything else seems to be working on MYBIOS?????
Yes, absolutely correct.
SETUP is only to install the BIOS, after that disregard this disk for ever.
LOAD is to load and start the system.
If loading fails, you get a message or scrambled colors.
But since you get the welcome menu, all is fine, oki doki, tip top, ready to go.
Now when you have NOT partitioned the hard-drive yet, ANY continue will boot D1 again;
-loads the BIOS and you are back to square one.
START sends you to the image-menu, but without partitioning this is garbage too.
SELECT sends you to the reset-menu.
OPTION selects BASIC and continue the boot-process, going in circles....
Any-key will continue the boot-process too, again circling around the point you are started with.
Since the same disk is still in drive one.....
But you can insert any other disk after the bios is loaded, then you continue there with mybios in control.
Try tapping HELP, keep tapping it.
But to be honest; START+SELECT+OPTION all together at once and keep them down must work.
Tested today with 2.0 GB hard-drive and 4.0GB CF with the PCB shown in the picture.
All works perfectly.
So my next step is to wait for your progress, tomorrow another day for me.
I'm sure you get it to work after this post.