It is currently Wed Jul 18, 2018 11:09 pm

All times are UTC - 5 hours




 Page 1 of 1 [ 2 posts ] 
Author Message
 Post subject: CTS CL as opposed to RI
PostPosted: Mon Jul 25, 2016 11:28 am 

Joined: Sat Jun 04, 2016 12:09 pm
Posts: 4
Hello,

Quick question.. I have been trying to get my Nick Kennedy SIO2PC to work with not only my registered version of APE.. but also AspeQt and RespeQt


One thing I have found is that RI as a signal line does not work as well with the PD software as it does with APE. My ape experience with RI has been no issue since the start.

SO.. I changed my signal line to CTS - again.. APE found it.. configured it.. no issues. Both of the other softwares now also work.

BUT the SIO seems faster - almost too fast.. the noises coming from file access is nasty like the sio sounds are so fast they are noise and static and farts etc.. as it goes through the access. Maybe with various fast io routines and then baud rates.. I am actually going too fast.. causing errors, which are retried.. correct.. and move on.. but the noise on my end sounds terrible.

Are there logs to view? if so .. what would indicate that things are moving too fast? just re-reads?

James


Offline
 Profile  
 
 Post subject: Re: CTS CL as opposed to RI
PostPosted: Mon Dec 18, 2017 12:10 am 
User avatar

Joined: Fri Feb 03, 2006 1:09 am
Posts: 124
Location: Galactic 0,0,0
RI has half the baud rate of CTS, and RI works on the falling edge of the RS232 timing signal. APE handles them all correctly. You can adjust the timing in APE as well.

Your Atari probably has the speed limiting caps on the SIO port, make sure they are removed otherwise the less desirable fix will be the same as below
Some software does not like high speed, copy protection schemes. Just set APE at slower SIO divisor in config.



_________________
_The Doctor__
Offline
 Profile  
 
Display posts from previous:  Sort by  
 Page 1 of 1 [ 2 posts ] 

All times are UTC - 5 hours


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  

cron