It is currently Wed Dec 02, 2020 1:08 am

All times are UTC - 5 hours




 Page 1 of 1 [ 1 post ] 
Author Message
 Post subject: SIOPC USB Interface Not Recognized by Atari Computer
PostPosted: Sun Sep 20, 2020 12:53 pm 

Joined: Mon Dec 26, 2011 12:04 am
Posts: 1
Hi,
I have a USB version of the SIO2PC interface and I am running APE for Windows on a Windows 10 laptop. The software loads and recognizes the interface, but when I try to access a disk image from my Atari 800XL, I am getting error 138. When the Atari boots, the center green LED flashes. It also flashes when I attempt to access the disk image.
I have tried setting the APE as drive 1, but then the Atari just boots to the Self Test. If I set the APE to drive 2 and use a boot disk in a physical drive, the Atari boots to the DOS screen, but drive 2 is not accessible, giving the above DOS error.
Any ideas as to what is causing this? I am running the most current version of the APE software with the 64-bit drivers.


Offline
 Profile  
 
Display posts from previous:  Sort by  
 Page 1 of 1 [ 1 post ] 

All times are UTC - 5 hours


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to: