Atarimax Product Discussion Forums
https://www.atarimax.com/flashcart/forum/

SIOPC USB Interface Not Recognized by Atari Computer
https://www.atarimax.com/flashcart/forum/viewtopic.php?f=5&t=3828
Page 1 of 1

Author:  Kylev [ Sun Sep 20, 2020 12:53 pm ]
Post subject:  SIOPC USB Interface Not Recognized by Atari Computer

Hi,
I have a USB version of the SIO2PC interface and I am running APE for Windows on a Windows 10 laptop. The software loads and recognizes the interface, but when I try to access a disk image from my Atari 800XL, I am getting error 138. When the Atari boots, the center green LED flashes. It also flashes when I attempt to access the disk image.
I have tried setting the APE as drive 1, but then the Atari just boots to the Self Test. If I set the APE to drive 2 and use a boot disk in a physical drive, the Atari boots to the DOS screen, but drive 2 is not accessible, giving the above DOS error.
Any ideas as to what is causing this? I am running the most current version of the APE software with the 64-bit drivers.

Author:  _The Doctor__ [ Sun Apr 11, 2021 4:23 pm ]
Post subject:  Re: SIOPC USB Interface Not Recognized by Atari Computer

Try making sure the disk drive is turned off when an image is inserted in APE's D1:

Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/