It is currently Thu Mar 28, 2024 4:17 am




 Page 1 of 1 [ 2 posts ] 
Author Message
 Post subject: Archived: SECAM 74LS574 modification instructions.
PostPosted: Thu Apr 14, 2011 11:12 pm 
ERROR AT LINE 0
User avatar

Joined: Tue Aug 05, 2003 9:55 am
Posts: 1042
Location: Cleveland, Ohio
Ok, here are the instructions for installing the address latch for those who wish to DIY.

I've tested it with a GAL16V8 but a 74LS574 should work the same. Instructions for using both are included.

1) Cut the traces shown, there are two on the front side just below the IDE connector, and one on the rear.

Image
Image

2) Take the programmed GAL16V8 or 74LS574 and bend up all of the pins except 10 and 20.

Solder this chip in place on top of the 74245 IC on the PC, with only pins 10 and 20 soldered to the IC below.

Image

3) Make the following connections:

E IC -> GND IC (Pin 11 to Pin 10 on GAL16V8, Pin 1 to Pin 10 on 74LS574)

A0 PCB -> A0 IC (Pin 2)
A1 PCB -> A1 IC (Pin 3)
A2 PCB -> A2 IC (Pin 4)

B0 IC -> B0 PCB (At IDE header pin shown, on front PCB)
B1 IC -> B1 PCB (At IDE header pin shown, on front PCB)
B2 IC -> B2 PCB (At IDE header pin shown, on rear PCB)

PCB o2 -> IC o2 (Pin 1 on GAL16V8, Pin 11 on 74LS574)

Image

Image

Image

Image

Image

Image

The equations and JED file for the GAL16V8 are attached.

Steve


There are images and/or files attached to this posting. You must be logged-in to view or download this content.


Offline
 Profile  
 
 Post subject: Re: Let's do something constructive about the MyIDE+F stabil
PostPosted: Sat Apr 16, 2011 2:56 am 
ERROR AT LINE 0
User avatar

Joined: Tue Aug 05, 2003 9:55 am
Posts: 1042
Location: Cleveland, Ohio
Sysop*Marius wrote:
Two other questions:

1. I also have an original AtariMax 1Mbit Flash card with MyIDE. The one where there is room for the original TTL chips. This board has different layout (as far as I can see that) I can not find the connection pads A0, A1 and A2 on this older (original) board.

2. Will this fix (with that GAL) also work on the original non-flash based MyIDE?


Hi Marius,

Here are the connection points for the older MyIDE+Flash with the TTL chip layouts. I don't have any of the original PCB on hand for real pictures but these are made from the PCB drawings.

Besides the different traces to cut and the different connection points, everything else should be the same.

Steve

Image Image Image


Offline
 Profile  
 
Display posts from previous:  Sort by  
 Page 1 of 1 [ 2 posts ] 


Who is online

Users browsing this forum: No registered users and 54 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  

cron